2021 EBY 53'x102"x13'6" Spread

SPECIFICATIONS:
-LENGTH: 53?
-WIDTH: 102?
-HEIGHT: 13?6?
-KING PIN: 30? DEEP, 49? HIGH
-FRONT DROP: 33-3/4?
-REAR DROP: 24-3/4" (LOWER REAR END 3?)
-LANDING GEAR: ALUM DROP LEG
-NON-STD DROPS CHARGE
-----RUNNING GEAR-----
-SUSPENSION: HENDRICKSON AIR RIDE (REAR END LOWERED 3?)
--SU15413 INTSUSP .23199
-AXLES: HENDRICKSON
-AXLE CONFIGURATION: 10?1? SPREAD
-AXLE TUCK: NONE
-DUMP VALVE: MANUAL W/ PRESSURE GAUGE
-HUBS: DUCTILE
-DRUMS: CAST
-**BRAKES:DISC BRAKES *
-DUST SHIELDS: NONE
-**ABS: 4S/2M*
-WHEELS: 22.5 (8) ALCOA LVL ONE ALUM

-TIRES: 295/75R22.5 GENERAL RA
-GVWR: 66,000 LBS
-----FLOOR-----
-MAIN FLOOR: .115 RIDGED DIAMOND PLATE
-REAR COMPARTMENT FLOOR: .115 RIDGED DIAMOND PLATE
-NOSE FLOOR: .115 RIDGED DIAMOND PLATE
-DRAINS: (2) CLEAVER STYLE BOTTOM REAR, (2) LIFT OUT REAR TOP DECK
-----FRONT END-----
-PANELS: MILL FINISHED ALUMINUM
-EXTRUDED CORNERS: SS OVERLAYS

-VENTS: (4) PUNCHED VENTS W/HINGED COVERS
-HANDLES/STEPS TO ACCESS VENTS: (4) STEPS (2) HANDLES TO ACCESS VENTS
-TIRE CARRIER: NONE
-LIGHTED SIGN: SS BOX
-NOSE BOX: SINGLE PLUG, DOUBLE BOX
-ADD I-BOLT ON FRONT END JUST ABOVE HALFWAY
-----REAR END-----
-**CURBSIDE: MILL FINISHED ALUM*

-ROADISDE: NEW STYLE SPLIT ROLL UP DOOR, CHAIN CONNECT

-- SAFETY GATE BOTTOM DECK- HINGE ON RS WALL

-CURBSIDE: PERMANENT PANEL
-WASH OUT: CS BOTTOM

-BUCKPLATE COVER: SS

-TOW HOOKS: YES

-BUMPERS VERTICAL: (2) 13? x 3? ON CORNERS
-BUMPER HORIZONTAL: FULL WIDTH 4?
-----ROOF-----
-MATERIAL: ALUMINUM
? REINFORCE W/ .080 SHEET MATERIAL & COVER W/ .040 ROOF MATERIAL
-HATCH: NONE
-----SIDE ASSEMBLY-----
-HOLE PATTERN: PPA
SIDE MATERIAL: MILL FINISH ALUM

-PANEL RETAINER CLIPS: YES

-CENTER SIDE DOORS: (4) 28-1/2" WIDE ON RS
--REMOVE INNER FLANGES THAT STOP DOOR & ADD FLATS TO DOOR TO STOP
-CLEAN OUT DOOR: (1) 24" x 16-3/4? ON RS
--ADDITIONAL CLEAN OUT DOOR ON RS TOP DECK & BOTTOM FRONT CS

-REAR SIDE DOOR: NONE
-----CLOSURE SYSTEMS-----
-CLOSURE PANELS: ½ KIT BLACK POLYMAX

-PLUGS: NONE
-----FRONT COMPARTMENT-----
-LENGTH: 120-5/8?
-DECK: STRAIGHT THRU
-----FRONT PARTITION-----
-ROADSIDE TOP: N/A
CURBSIDE TOP: FULL SWING GATE HINGED ON CS
ROADSIDE BOTTOM: N/A
CURBSIDE BOTTOM: FULL SWING GATE
FUNNEL GATE: NONE
NOTE: FRONT GATE ON TOP DECK TO BE HINGED ON CS AND REAR GATE TO BE HINGED ON RS
-----CENTER COMPARTMENT ? BOTTOM-----
-LENGTH: 28'
-DOWN RAMP: STD
-DECK RAILS: NONE
-DECKING: NONE
-DECK STORAGE: NONE
-GATES: (1) CENTERED, PAN STYLE
-GATE OPTIONS: NONE
-----CENTER COMPARTMENT ? TOP-----
-LENGTH: MID DECK TO BE SET AHEAD 9" FROM REAR PARTITION
-DECK RAILS: NONE
-DECKING: NONE
-DECK STORAGE: NONE
-GATES: (1) CENTERED, PAN STYLE
-HINGE THIS GATE ON ROADSIDE
-----REAR PARTITION-----
-ROADSIDE TOP: SWING (CHAIN TO BE ONLY 26")
-THIS GATE TO SWING AND LATCH IN BOTH DIRECTIONS*
-CURBSIDE TOP: COMBO
-BOTTOM: CENTER SWING
-----REAR COMPARTMENT-----
-LENGTH: 15'
-PULL OUT CHUTE: 126? FOLD TO WALL

-CHUTE SIDE: FOLD TO CORNER
--ADD?L SETTING ON CS WALL 18" BACK FROM REAR PARTITION

-- ADD PIN TO CHUTE SIDE WHEN STORED AGAINST WALL
-JAIL HOUSE: ½ PERMANENT, PAN STYLE
-----LIGHTS-----
-SIDE LIGHTS: (3) ROWS OF , (9) LITES BETWEEN TOP RAIL AND DROP
LINES, (5) BELLY, TO ALL BE PENNY STYLE*
-SIDE REAR POST: (4) UP EACH
-REAR HEADER: (3) BRAKE, CLEARANCE
-REAR POST: (2) HIGH MOUNT TURN, CLEARANCE
-BUCK PLATE: (2) BRAKE/CLEARANCE, (1) TURN/CLEARANCE EACH SIDE
-ADD MID-SPAN TURN SIGNAL
-INSIDE LIGHTS: (10) LED
-INSTALL (3) INTERIOR LITES IN BELLY SPACED EVENLY
-LOAD LIGHTS: (2) BELOW REAR HEADER, POSITION AT TOP
-----MISCELLANEOUS-----
-MUD FLAPS: BLACK RUBBER W/ POLISHED EBY WEIGHTS
-CLOSURE STORAGE: PANEL BOX BETWEEN SPREAD
-----NOTES-----
-NO SPRING PINS ON BOTTOM OF GATES WHEN CLOSED ? DROP PINS ONLY